Kunci Jawaban CCNA 1 Version 6.0 Chapter 6 Exam Update 2018
Selamat berjumpa kembali di bsi-tips pada kesempatan kali ini admin akan memberitahukan soal serta jawaban dari test Cisco CCNA 1 Chapter 6 Version 6.0 yang kalian dapat akses melalui website official cisco.
Soal ini berjumlah 20 butir soal dengan pilihan ganda dan menggunakan bahasa inggris. untuk mempermudah kalian dalam mengerjakan gunakan kombinasi pada keyboard kalian untuk mencari kata. tekan CTRL+F untuk mencari kata pada blog ini.
1. Which three commands are used to set up secure access to a router through a connection to the console interface (Choose three.)
2. A router boots and enters setup mode. what is the reason for this?
3. What type of route is indicated by the code C in an IPv4 routing table on a Cisco router?
4. When a connectionless protocol is in use at a lower layer of the OSI model, how is missing data detected and retransmitted if necessary?
5. What are two characteristics of IP? (Choose two.)
6. What are two types of router interfaces? (Choose two.)
7. Which characteristic describes an IPv6 enhancement over IPv4?
8. Refer to the exhibit. Which route from the PC1 routing table will be used to reach PC2?
A.
B.
C.
D.
Jawabannya : A
9. What is the purpose of the startup configuration file on a Cisco router?
10. Following default settings, what is the next step in the router boot sequence after the IOS loads from flash?
11. Match the command with the device mode at which the command is entered. (Not all options are used.)
12. What is one advantage that the IPv6 simplified header offers over IPv4?
13. Refer to the exhibit. R1 receives a packet destined for the IP address 192.168.2.10. Out which interface will R1 forward the packet?
14. Open the PT Activity. The enable password on all devices is cisco.
Perform the tasks in the activity instructions and then answer the question.
For what reason is the failure occurring?
15. Which characteristic of the network layer in the OSI model allows carrying packets for multiple types of communications among many hosts?
16. Which field in the IPv4 header is used to prevent a packet from traversing a network endlessly
17. Which statement describes a hardware feature of a Cisco 1941 router that has the default hardware configuration?
18. Which two pieces of information are in the RAM of a Cisco router during normal operation? (Choose two.)
19. What routing table entry has a next hop address associated with a destination network?
20. What IPv4 header field identifies the upper layer protocol carried in the packet?
Demikian soal serta jawaban dari CCNA 1 Chapter 6 Exam Version 6.0 yang berjumlah 20 butir soal. Semoga artikel ini dapat membantu sobat bsi-tips semua dalam mengerjakan test ini. Selamat mengerjakan ! sampai jumpa di artikel berikutnya .
Soal ini berjumlah 20 butir soal dengan pilihan ganda dan menggunakan bahasa inggris. untuk mempermudah kalian dalam mengerjakan gunakan kombinasi pada keyboard kalian untuk mencari kata. tekan CTRL+F untuk mencari kata pada blog ini.
1. Which three commands are used to set up secure access to a router through a connection to the console interface (Choose three.)
- line vty 0 4
- interface fastethernet 0/0
- login
- password cisco
- line console 0
- enable secret cisco
2. A router boots and enters setup mode. what is the reason for this?
- The configuration file is missing from NVRAM.
- Cisco IOS is missing from flash memory
- The IOS image is corrupt.
- The POST process has detected hardware failure.
3. What type of route is indicated by the code C in an IPv4 routing table on a Cisco router?
- Default route
- Directly Connected Route
- Dynamic route that is learned through EIGRP
- Static route
4. When a connectionless protocol is in use at a lower layer of the OSI model, how is missing data detected and retransmitted if necessary?
- Connectionless acknowledgements are used to request retransmission
- Network layer IP protocols manage the communication sessions if connection-oriented transport services are not available.
- Upper-layer connection-oriented protocols keep track of the data received and can request retransmission from the upperlevel protocols on the sending host.
- The best-effort delivery process guarantees that all packets that are sent are received
5. What are two characteristics of IP? (Choose two.)
- retransmits packets if errors occur
- does not require a dedicated end-to-end connection
- guarantees delivery of packets
- re-assembles out of order packets into the correct order at the receiver end
- operates independently of the network media
6. What are two types of router interfaces? (Choose two.)
- SVI
- LAN
- DHCP
- Telnet
- WAN
7. Which characteristic describes an IPv6 enhancement over IPv4?
- Both IPv4 and IPv6 support authentication, but only IPv6 supports privacy capabilities.
- The IPv6 header is simpler than the IPv4 header is, which improves packet handling.
- IPv6 addresses are based on 128-bit flat addressing as opposed to IPv4 which is based on 32-bit hierarchical addressing.
- The IPv6 address space is four times bigger than the IPv4 address space.
8. Refer to the exhibit. Which route from the PC1 routing table will be used to reach PC2?
A.
B.
C.
D.
Jawabannya : A
9. What is the purpose of the startup configuration file on a Cisco router?
- to contain the configuration commands that the router IOS is currently using
- to provide a limited backup version of the IOS, in case the router cannot load the full featured IOS
- to contain the commands that are used to initially configure a router on startup
- to facilitate the basic operation of the hardware components of a device
10. Following default settings, what is the next step in the router boot sequence after the IOS loads from flash?
- Perform the POST routine.
- Load the bootstrap program from ROM.
- Locate and load the startup-config file from NVRAM.
- Load the running-config file from RAM.
11. Match the command with the device mode at which the command is entered. (Not all options are used.)
12. What is one advantage that the IPv6 simplified header offers over IPv4?
- smaller-sized header
- little requirement for processing checksums
- smaller-sized source and destination IP addresses
- efficient packet handling
13. Refer to the exhibit. R1 receives a packet destined for the IP address 192.168.2.10. Out which interface will R1 forward the packet?
- FastEthernet0/0
- FastEthernet0/1
- Serial0/0/0
- Serial0/0/1
14. Open the PT Activity. The enable password on all devices is cisco.
Perform the tasks in the activity instructions and then answer the question.
For what reason is the failure occurring?
- PC1 has an incorrect default gateway configured.
- SW1 does not have a default gateway configured.
- The IP address of SW1 is configured in a wrong subnet.
- PC2 has an incorrect default gateway configured.
15. Which characteristic of the network layer in the OSI model allows carrying packets for multiple types of communications among many hosts?
- the de-encapsulation of headers from lower layers
- the selection of paths for and direct packets toward the destination
- the ability to operate without regard to the data that is carried in each packet
- the ability to manage the data transport between processes running on hosts
16. Which field in the IPv4 header is used to prevent a packet from traversing a network endlessly
- Time-to-Live
- Sequence Number
- Acknowledgment Number
- Differentiated Services
17. Which statement describes a hardware feature of a Cisco 1941 router that has the default hardware configuration?
- It does not have an AUX port.
- It has three FastEthernet interfaces for LAN access.
- It has two types of ports that can be used to access the console.
- It does not require a CPU because it relies on Compact Flash to run the IOS.
18. Which two pieces of information are in the RAM of a Cisco router during normal operation? (Choose two.)
- Cisco IOS
- backup IOS file
- IP routing table
- basic diagnostic software
- startup configuration file
19. What routing table entry has a next hop address associated with a destination network?
- directly-connected routes
- local routes
- remote routes
- C and L source routes
20. What IPv4 header field identifies the upper layer protocol carried in the packet?
- Protocol
- Identification
- Version
- Differentiated Services
Demikian soal serta jawaban dari CCNA 1 Chapter 6 Exam Version 6.0 yang berjumlah 20 butir soal. Semoga artikel ini dapat membantu sobat bsi-tips semua dalam mengerjakan test ini. Selamat mengerjakan ! sampai jumpa di artikel berikutnya .
Makasih gan :)
ReplyDelete